Input Menu - Sim2 NERO 3 PLUS Quick Start Manual

Switching Off
I. Press the "|" button on the remote control or the button on the back panel of the
projector one time. The following message will be displayed on the screen.
Press the "|" button on the remote control, or the on the back panel again to confirm,
otherwise the message will disappear after 15 seconds. When you press the "|" button for the
second time, the projector will shut down (the interval between pressing has to be around one
second to turn off the projector).
II. The cooling fans continue to operate for about 10 seconds for cooling cycle and the
Power LED will flash blue. When the Power LED lights solid red, the projector has entered
in standby mode. If you wish to turn the projector back on, you must wait until the
projector has completed the cooling cycle and has entered standby mode. Once in
standby mode, simply press the button on the back panel or the " " on the remote
control to restart the projector.
III. Disconnect the power cord from the electrical outlet and the projector.
Warning: Do not turn on the projector immediately following a power off procedure.
Input Menu
Press the menu button on the remote control and go to "SETUP" to enter into the Input
Source menu, or directly select the desired input by pressing the corresponding button on the
remote control (HDMI1, HDMI2, VGA, etc) or press the SOURCE button on the back panel.
Use this option to enable/disable input source.
Press ! to enter the sub menu, press " or # on the remote control to highlight the input, and
select which sources you require. Press ! to finalize the selection. The projector will only
search for inputs that are enabled.
Press on the remote control to exit from the Input Source menu.