Chapter 3: Installation; Location - Sim2 Sirio User Manual

3 Installation
This section provides instructions for the installation of the SIRIO projector.
Important:
specialist.

Location

When installing the SIRIO projector, take the following considerations into account.
Installation Type
Select the installation type that best suits your needs:
•front or rear projection
•floor or ceiling mount
Lens Type
Choose the desired distance from the screen and select the lens type (M0, M1, M2,
M3, M4) that determines the desired screen size (see "Projections Distances" on page
42).
Cooling
Make sure that the planned location for the projector has adequate ventilation. Check
that room temperature is below 35° C and that the projector is away from heating
vents. Ensure a minimum 0.25 m (10 in.) clearance on the left, right and rear sides of
the projector.
Power Outlets
Verify that the powers outlets are grounded and preferably shielded from power
surges and fluctuations. SIRIO power supply operates on any nominal line voltage
between 100-240 V AC, 50-60 Hz.
Cables
Check planned cable lengths for video and control cables and make sure these lengths
do not exceed specifications.
Ambient Light
Avoid or minimize light sources directed at the screen to preserve the quality of the
projected image.
3 Installation
Installation procedures should be performed by a qualified AV system
SIRIO 13
User Guide