Mounting - Sim2 Sirio User Manual

Mounting

The projector can be Floor mounted (upright) or Ceiling mounted (inverted). Choose
the method that best suits your installation.
Important:
the lens is centered horizontally to the center of the screen before installing.
Floor Mounting
Position the projector on a secure and flat surface (such as a table or a shelf). Adjust
front feets at the bottom of the projector until the projector is level on all sides.
Ceiling Mounting
Invert the projector and suspend it from the ceiling using a specific bracket.
•Attach bracket by using 4 x M8 screws not exceeding 16 mm in length
Orientation
By default, the SIRIO is configured for a Front installation (projector installed upright
and in front of the screen). If the projector is installed behind the screen or inverted,
you can use the image orientation function of the projector (see "Orientation" on
page 31)
Vertical Lens Shift
Ideally, the projector should be positioned perpendicular to the screen and in such a
way that:
•the lens center and screen center are aligned with each other
•the projected image fills the screen perfectly
3 Installation
The projection lens is centered to the chassis. Make sure the centerline of
For ceiling mounting use only SIM2-approved ceiling brackets and adhere
to the installation instructions and safety guidelines provided with the
bracket. Do not over-tighten the screws.
SIRIO 16
User Guide