Editing In "Video" Mode - Roundshot VR Drive Instruction Manual

4.2

Editing in "video" mode

Click on the "program info" section to open the "program edit" menu.
In this menu all program parameters can be changed. It also allows to access the VR Drive settings.
Video project
Canon 5D
focal length : 50mm
start position X: 0° Y: 0°
points : 2
P1: 45°/45 P2: -99°/13
timer : 0s
repeat : 0
All program parameters can be accessed and modified one by one.
The parameters for the "video" mode are very specific. This is why it cannot be changed into
another mode (such as "quality", "speed" or "turntable").
In the "video" mode edit menu the program parameters can be modified in the same way as for the
"quality", "speed" or "turntable" modes. For example, it is possible to change the program info text,
the camera, the focal length, the release time, program repetition, timer and the manual function.
In addition to these modes, the "video" mode allows to edit the video type (filming or timelapse),
the starting position as well as the points for the video sweep.
Please note that the image release mode (seconds or angle for timelapse) cannot be edited as this
variable creates an entirely different image release behaviour.
start
0/0°
X
Y
°
°
0
0
[-999.9..999.9] [-90.0..90.0]
Instruction Manual Roundshot VR Drive version 2.03 – April 2012 – © by Seitz Phototechnik AG / Switzerland www.roundshot.ch
Edit P6 / page 1
mode
info
video
Canon
focal length
5D
50mm
image release
video type
mode
timelapse
angle
start
points
0/0°
Click on "start position" to change initial position from which the
VR Drive launches the video sweep.
By default, the VR Drive starts from 0° / 0° to reach the first point
defined in the "Program Wizard".
Enter the "X" and "Y" coordinates of the starting point.
Confirm with "OK".
Edit P6 / page 2
repeat
release time
0
0.1s
timer
manual
0s
off
settings
page 97