220i Integrated Amplifier Important Safety Instructions Read these instructions. Keep these instructions. Heed all warnings. Follow all instructions. Do not use this apparatus near water. Clean only with a dry cloth. Do not block ventilation openings. Install in accordance with the manufacturer’s instructions. Do not install near any heat sources such as radiators, heat registers, stoves or another apparatus that produces heat.
Page 4
To prevent shock hazard, all three connections must ALWAYS be used. Connect the MOON 220i only to an AC source of the proper voltage; Both the shipping box and rear panel serial number label will indicate the correct voltage. Use of any other voltage will likely damage the unit and void the warranty AC extension cords are NOT recommended for use with this product.
MOON capturing these elusive qualities. integrated amplifiers are so musically satisfying. The information contained in this manual is subject The performance of your 220i will continue to to change without notice.
220i Integrated Amplifier Unpacking The Nēo 220i integrated amplifier should be removed from its box with care. The following accessories should be included inside the box with your integrated amplifier: AC power cable ‘CRM-2’ remote control with two ‘AA’ batteries This owner’s manual Warranty and product registration information (USA and Canada only)
220i Integrated Amplifier Front Panel Controls Figure 1: Nēo 220i Front panel The front panel will look similar to Figure 1 (above). The “Spk off” button turns off the output signal only The remote control sensor is located directly to the to the loudspeakers connected to the Nēo 220i.
“SimLink™” connectors labeled “in” and “out” on 1/8” mini jacks. Please refer to the next section * Please speak with your MOON Authorized Retailer about entitled SimLink™ for more details. Next, there’s a the benefits of high quality cables for your system, and 1/8”...
The SimLink™ provides communication features Streamer; When you press the (play) button on between various MOON components. For example, the “MiND” App, the 220i will automatically switch if you were to connect the 260D to the 220i via the to the input labeled ‘Aux’. You can change these SimLink™, pressing the...
The Nēo 220i Integrated Amplifier uses the ‘CRM-2’ full-function remote control (figure 4). It operates on the Philips RC-5 communication protocol and is can be used with other Simaudio MOON components. The ‘CRM-2’ remote uses two AA batteries (included). To install them, simply slide the back plate off in the direction of the arrow;...
Page 12
220i Integrated Amplifier Remote operation with multiple MOON components Figure 4: Remote Operation with SimLink™ In figure 4 we have a 180 MiND Music Streamer and Apple smart device (full list on the MiND page of our a Nēo 220i Integrated Amplifier connected together website) and select this system’s ZONE, both the...