Clustering Management Configuration - ZyXEL Communications MES3500 Series User Manual

41.2.1.1 Uploading Firmware to a Cluster Member Switch
You can use FTP to upload firmware to a cluster member switch through the cluster manager switch
as shown in the following example.
Figure 203 Example: Uploading Firmware to a Cluster Member Switch
C:\>ftp 192.168.1.1
Connected to 192.168.1.1.
220 Switch FTP version 1.0 ready at Thu Jan
User (192.168.0.1:(none)): admin
331 Enter PASS command
Password:
230 Logged in
ftp> ls
200 Port command okay
150 Opening data connection for LIST
--w--w--w-
--w--w--w-
-rw-rw-rw-
226 File sent OK
ftp: 297 bytes received in 0.00Seconds 297000.00Kbytes/sec.
ftp> bin
200 Type I OK
ftp> put 400AABB0B1.bin ras-0
200 Port command okay
150 Opening data connection for STOR ras-0
226 File received OK
ftp: 262144 bytes sent in 0.63Seconds 415.44Kbytes/sec.
ftp>
The following table explains some of the FTP parameters.
Table 145 FTP Upload to Cluster Member Example
FTP PARAMETER
User
Password
ls
400AABB0B1.bin
ras-0
config

41.3 Clustering Management Configuration

Use this screen to configure clustering management. Click Management > Cluster Management
> Configuration to display the next screen.
Chapter 41 Cluster Management
1 owner group
1 owner group
1 owner group
DESCRIPTION
Enter "admin".
The web configurator password default is 1234.
Enter this command to list the name of cluster member switch's firmware and
configuration file.
This is the name of the firmware file you want to upload to the cluster member
switch.
This is the cluster member switch's firmware name as seen in the cluster
manager switch.
This is the cluster member switch's configuration file name as seen in the
cluster manager switch.
MES3500/MGS3520 Series User's Guide
1 00:58:46 1970
3082906 Jul 01 12:00 ras-0
3082906 Jul 01 12:00 ras-1
8388608 Jul 01 12:00 config
308