Mvr Configuration Example - ZyXEL Communications MES3500 Series User Manual

Layer 2 management switch
Hide thumbs Also See for MES3500 Series:
Table of Contents

Advertisement

The following table describes the labels in this screen.
Table 66 Advanced Application > Multicast > Multicast Setting > MVR: Group Configuration
LABEL
Multicast
VLAN ID
Name
Start Address
End Address
Add
Cancel
MVLAN
Name
Start Address
End Address
Delete
Cancel

24.8.1 MVR Configuration Example

The following figure shows a network example where ports 1, 2 and 3 on the Switch belong to VLAN
1. In addition, port 7 belongs to the multicast group with VID 200 to receive multicast traffic (the
News and Movie channels) from the remote streaming media server, S. Computers A, B and C in
VLAN 1 are able to receive the traffic.
Figure 106 MVR Configuration Example
VLAN 1
A
C
To configure the MVR settings on the Switch, create a multicast group in the MVR screen and set
the receiver and source ports.
Chapter 24 Multicast
DESCRIPTION
Select a multicast VLAN ID (that you configured in the MVR screen) from the drop-down list
box.
Enter a descriptive name for identification purposes.
Enter the starting IP multicast address of the multicast group in dotted decimal notation.
Refer to
Section 24.1.1 on page 175
Enter the ending IP multicast address of the multicast group in dotted decimal notation.
Enter the same IP address as the Start Address field if you want to configure only one IP
address for a multicast group.
Refer to
Section 24.1.1 on page 175
Click Add to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
This field displays the multicast VLAN ID.
This field displays the descriptive name for this setting.
This field displays the starting IP address of the multicast group.
This field displays the ending IP address of the multicast group.
Select Delete All or Delete Group and click Delete to remove the selected entry(ies) from
the table.
Select Cancel to clear the checkbox(es) in the table.
1
2
3
B
MES3500/MGS3520 Series User's Guide
for more information on IP multicast addresses.
for more information on IP multicast addresses.
Multicast VID 200
7
186
News: 224.1.4.10 ~ 224.1.4.50
Movie: 230.1.2.50 ~230.1.2.60
S

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mgs3520 series

Table of Contents