Arp Inspection Vlan Status - ZyXEL Communications MES3500 Series User Manual

Table 82 ARP Inspection Status (continued)
LABEL
MAC Address
VID
Port
Expiry (sec)
Reason
Delete
Delete
Cancel

26.6.1 ARP Inspection VLAN Status

Use this screen to look at various statistics about ARP packets in each VLAN. To open this screen,
click Advanced Application > IP Source Guard > ARP Inspection > VLAN Status.
Figure 124 ARP Inspection VLAN Status
The following table describes the labels in this screen.
Table 83 ARP Inspection VLAN Status
LABEL
Show VLAN
range
Enabled VLAN
Selected VLAN
Apply
VID
Chapter 26 IP Source Guard
DESCRIPTION
This field displays the source MAC address in the MAC address filter.
This field displays the source VLAN ID in the MAC address filter.
This field displays the source port of the discarded ARP packet.
This field displays how long (in seconds) the MAC address filter remains in the Switch. You
can also delete the record manually (Delete).
This field displays the reason the ARP packet was discarded.
MAC+VLAN: The MAC address and VLAN ID were not in the binding table.
IP: The MAC address and VLAN ID were in the binding table, but the IP address was not
valid.
Port: The MAC address, VLAN ID, and IP address were in the binding table, but the port
number was not valid.
Select this and click Delete to remove the specified entry.
Click this to remove the selected entries.
Click this to clear the Delete check boxes above.
DESCRIPTION
Use this section to specify the VLANs you want to look at in the section below.
Select this to look at all the VLANs on which ARP inspection is enabled in the section below.
Select this to look at all the VLANs in a specific range in the section below. Then, enter the
lowest VLAN ID (Start VID) and the highest VLAN ID (End VID) you want to look at.
Click this to display the specified range of VLANs in the section below.
This field displays the VLAN ID of each VLAN in the range specified above.
MES3500/MGS3520 Series User's Guide
215