Configuring 2-Rate 3 Color Marker Settings - ZyXEL Communications MES3500 Series User Manual

Figure 160 IP Application > DiffServ
The following table describes the labels in this screen.
Table 108 IP Application > DiffServ
LABEL
Active
Port
*
Active
Apply
Cancel

35.3.1 Configuring 2-Rate 3 Color Marker Settings

Use this screen to configure TRTCM settings. Click the 2-rate 3 Color Marker link in the DiffServ
screen to display the screen as shown next.
Note: You cannot enable both TRTCM and Bandwidth Control at the same time.
Chapter 35 Differentiated Services
DESCRIPTION
Select this option to enable DiffServ on the Switch.
This field displays the index number of a port on the Switch.
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first
to set the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Select Active to enable DiffServ on the port.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
MES3500/MGS3520 Series User's Guide
255