Table of Contents
Advertisement
The following table describes the labels in this screen.
Table 28 Advanced Application > Spanning Tree Protocol > Configuration
LABEL
Spanning Tree
Mode
Apply
Cancel
13.4 Configure Rapid Spanning Tree Protocol
Use this screen to configure RSTP settings, see
RSTP. Click RSTP in the Advanced Application > Spanning Tree Protocol screen.
Figure 64 Advanced Application > Spanning Tree Protocol > RSTP
Chapter 13 Spanning Tree Protocol
DESCRIPTION
You can activate one of the STP modes on the Switch.
Select Rapid Spanning Tree, Multiple Rapid Spanning Tree or Multiple Spanning
Tree. See
Section 13.1 on page 112
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Click Cancel to begin configuring this screen afresh.
MES3500/MGS3520 Series User's Guide
118
for background information on STP.
Section 13.1 on page 112
for more information on
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
