Record Setting - Avermedia SA5104 User Manual

10.2.2.3

Record Setting

In the Recording setup windows, click OK to accept the new settings, click Exit to exit without saving, and
click Default to revert back to original factory setting.
(1)
(2)
(3)
(4)
(5)
(6)
(1) Camera Icons
Select the camera number you want to set the recording setting. To select all the cameras, enable the ALL
check box. To select more than one camera, Right click on the camera icon. To select one camera only, Left
click on the camera icon. The camera icon turns red when it is selected.
(2) Recording Mode
The blocks from 00 to 23 represent the time in 24-hour clock. To record in full 24 hours, select the recording
mode and click the
recording mode then click on the time blocks. When the system starts recording a red triangle mark would
appear at the upper left corner of the screen. The recording modes are listed below:
- Always Recording
Record the video from the selected camera and save it to the designated storage path
- Motion Recording
Start recording the video from the selected camera only when the system detects movement. Once a
motion is detected, the system automatically saves the previous frames and stop based on the Start
Record Prior and Stop Record After settings.
- Smart Recording
Automatically switch to recorded at the maximum frame rate setting once a motion is detected and if
there is no motion, it records at the minimum frame rate setting. Set the maximum and minimum frame
rate setting in
(5) Frame Rate
- No Recording
The system won't do any recording.
(3) Motion Detection
Adjust the sensitivity of the motion detector. The higher the value, the finer the sensitivity is detected. When
it detects a motion, a green triangle mark would appear at the upper left corner of the screen.
(4) Quality
Adjust the video quality. The higher the value, the lower the compression level and uses more hard disk
space.
(5) Frame Rate
Set the maximum number of frames to be recorded during motion and motionless state. The frame rate
button. If you want to only record at a particular time, click the colored block beside the
section.
119
(7)
(8)