Back Panel; Setting Up The Dvr Unit; Installing The Hard Disk - Avermedia AVerDiGi EB1304 MPEG4+ Operation Manual

1.4

Back Panel

Name
(1) Audio Out
(2) Audio In
(3) CH1
(4) CH2
(5) CH3
(6) CH4
(7) Video Out
(8) VGA OUT
(9) Sensor In &
Alarm Out
(10) TV-VGA
(11) 12V DC
1.5

Setting Up the DVR Unit

1.5.1 Installing the Hard Disk

The DVR unit allows you to install one hard disk. Before installing the hard disk,
make sure to set the hard disk master jumper setting. Adjust the jumper setting
according to the instructions on the hard disk label.
i
Use 40GB/ 7200RPM IDE hard disk or larger is recommended
Function
: Output the audio signal to a speaker
: Input the audio signal from a microphone or audio output device.
The audio is embedded with channel 1
: Input the video camera signal and display it on channel 1
: Input the video camera signal and display it on channel 2
: Input the video camera signal and display it on channel 3
: Input the video camera signal and display it on channel 4
: Output the video signal to a TV
The DVR unit support 2 video output ports and you can
only select to output the video either from the VGA OUT or
VIDEO OUT
: Output the video signal to a CRT or LCD monitor
: Support up to 4 sensor device and 1 relay device (Relay: 1A @
125V AC/30V DC)
: Switch to select the video output. Make sure to set the video output
before turning on the unit
: Connect the power adapter into this port
4