Record Setting - Avermedia NV 3000 User Manual

i Noise Reduction uses lots of CPU resource. Please use this feature only if it is
really necessary.
(6) Auto Brightness Control
Automatically adjust the brightness.
(7) Night View
Automatically adjust the exposure to make the image more visible especially when the site is
dark. You can only use this function when the Auto Brightness Control is enabled.
(8) Video Screen
Display the video of the selected camera.

Record Setting

In the Recording setup windows, click OK to accept the new settings, click Exit to exit without
saving, and click Default to revert back to original factory setting.
(1)
(2)
(3)
(4)
(5)
(6)
(1) Camera Icons
Select the camera number you want to set the recording setting. To select all the cameras,
enable the ALL check box. To select more than one camera, Right click on the camera icon.
To select one camera only, Left click on the camera icon. The camera icon turns red when it
is selected.
(2) Recording Mode
The blocks from 00 to 23 represent the time in 24-hour clock. To record in full 24 hours, select
the recording mode and click the
the colored block beside the recording mode then click on the time blocks. When the system
starts recording a red triangle mark would appear at the upper left corner of the screen. The
recording modes are listed below:
- Always Recording
Record the video from the selected camera and save it to the designated storage path
- Motion Recording
Start recording the video from the selected camera only when the system detects
movement. Once a motion is detected, the system automatically saves the previous
frames and stop based on the Start Record Prior and Stop Record After settings.
- Smart Recording
button. If you want to only record at a particular time, click
135
(7)
(8)