Factory Default - Planet Networking & Communication IGSW-24040T User Manual

4.2.21 Factory Default

You can reset the configuration of the switch on this page. Only the IP configuration is retained. The new configuration is
available immediately, which means that no restart is necessary. The Factory Default screen in
Buttons
: Click to reset the configuration to Factory Defaults.
: Click to return to the Port State page without resetting the configuration.
After the "Factory" button be pressed and rebooted, the system will load the default IP settings as following:
Default IP address: 192.168.0.100
。
Subnet mask: 255.255.255.0
。
Default Gateway: 192.168.0.254
。
The other setting value is back to disable or none.
。
To reset the Managed Switch to the Factory default setting, you can also press the hardware reset button
at the front panel about 10 seconds. After the device be rebooted. You can login the management WEB
interface within the same subnet of 192.168.0.xx.
Figure 4-2-28 Factory Default Page Screenshot
Hardware Reset button
77
User's Manual of IGSW-24040T
Figure 4-2-28 appears.