Planet Networking & Communication IGSW-24040T User Manual page 128

VLAN Group 2
VLAN Group 3
The scenario described as follow:

Untagged packet entering VLAN 2
While [PC-1] transmit an untagged packet enters Port-1, the Managed Switch will tag it with a VLAN Tag=2.
1.
[PC-2] and [PC-3] will be received the packet through Port-2 and Port-3.
[PC-4],[PC-5] and [PC-6] received no packet.
2.
While the packet leaves Port-2, it will be stripped away it tag becoming an untagged packet.
3.
While the packet leaves Port-3, it will keep as a tagged packet with VLAN Tag=2.
4.

Tagged packet entering VLAN 2
While [PC-3] transmit a tagged packet with VLAN Tag=2 enters Port-3, [PC-1] and [PC-2] will received the packet
5.
through Port-1 and Port-2.
While the packet leaves Port-1 and Port-2, it will be stripped away it tag becoming an untagged packet.
6.

Untagged packet entering VLAN 3
1. While [PC-4] transmit an untagged packet enters Port-4, the switch will tag it with a VLAN Tag=3. [PC-5] and
[PC-6] will be received the packet through Port-5 and Port-6.
2. While the packet leaves Port-5, it will be stripped away it tag becoming an untagged packet.
3. While the packet leaves Port-6, it will keep as a tagged packet with VLAN Tag=3.
At this example, VLAN Group 1 just set as default VLAN, but only focus on VLAN 2 and VLAN 3 traffic
flow
Setup steps
1. Create VLAN Group
Set VLAN Group 1 = Default-VLAN with VID (VLAN ID) =1
Add two VLANs – VLAN 2 and VLAN 3
VLAN Group 2 with VID=2
VLAN Group 3 with VID=3
2. Assign VLAN Member:
VLAN 2: Port-1, Port-2 and Port-3
2 Port-1, Port-2
3 Port-4, Port-5
Table 4-6-2 VLAN and Port Configuration
128
User's Manual of IGSW-24040T
Port-3
Port-6