Maintenance; Factory Default - Planet Networking & Communication WGS-4215-8P2S User Manual

4.16 Maintenance

Use the Maintenance menu items to display and configure basic configurations of the Managed Switch. Under maintenance, the
following topics are provided to back up, upgrade, save and restore the configuration. This section has the following items:

■ Factory Default

■ Reboot Switch
■ Backup Manager
■ Upgrade Manager
■ Dual Image
4.16.1 Factory Default
You can reset the configuration of the switch on this page. Only the IP configuration is retained. The new configuration is
available immediately, which means that no restart is necessary. The Factory Default screen in
to reset the configuration to Factory Defaults.
After the "Factory" button is pressed and rebooted, the system will load the default IP settings as follows:
Default IP address: 192.168.0.100
。
Subnet mask: 255.255.255.0
。
Default Gateway: 192.168.0.254
。
The other setting value is back to disable or none.
。
To reset the Managed Switch to the Factory default setting, you can also press the hardware reset button
at the front panel about 10 seconds. After the device be rebooted. You can login the management WEB
interface within the same subnet of 192.168.0.xx.
You can reset the configuration of the switch on this page.
You can restart the switch on this page. After restart, the switch will boot
normally.
You can back up the switch configuration.
You can upgrade the switch configuration.
Select active or backup image on this Page.
Figure 4-16-1 Factory Default Page Screenshot
343
User's Manual of WGS Managed Series
Figure 4-16-1 appears and clicks