Basic Function Instruction; Startup And Shutdown; Startup; Shutdown - Provision ISR IP series User Manual

3

Basic Function Instruction

3.1

Startup and Shutdown

Please make sure all the connections are done properly before you power on the unit. Proper startup and
shutdown are crucial to expanding the life of your NVR.
3.1.1

Startup

Step 1: Connect with the source power.
Step 2: The device will boot and the power LED would turn blue.
Step 3: A "WIZZARD" window will pop up and show some information about time zone, time setup,
network configuration, record configuration and disk management. You can set up here and refer to the
concrete setup steps from the corresponding chapters. If you don't want to set up Wizard, please click Exit
button to exit.
Note: The default output is HDMI output. Hold and press Fn/Esc key to switch the output among
CVBS, VGA & HDMI.
3.1.2

Shutdown

You can shut down the device by using IR remote controller and mouse.
By IR remote controller:
Step 1: Press Power button. This will bring up a shutdown window. The unit will shut down by clicking "OK"
button.
Step 2: Disconnect the power.
By mouse:
Step 1: Enter into
Step 2: Click OK. Then the unit will power off after a while.
Step 3: Disconnect the power.
Menu and select "Shut Down" icon. This will take you to a shutdown window.