Qrcode; Manual Alarm; Disk Management; Upgrade - Provision ISR IP series User Manual

7.1.7

QRCODE

User can quickly access the mobile client by scanning QRCODE. Go to Main menu→Information→QRCODE
tab. In this interface, you can scan the QRCODE through the mobile phone. Refer to Fig 6-2:
7.2

Manual Alarm

In this interface, user can trigger a manual alarm.
7.3

Disk Management

1. Format the disk
Step1: Enter into disk management tab.
Note: please format the hard disk before recording. If not formatted, it will show the status of the disk-free space, and total space at
the bottom of screen.
Step2: Click Refresh button to refresh the disk information in the list box.
Step3: Select a hard disk and click Format button to start format.
Note: All recorded files in the hard disk will be lost once it is formatted.
2. Advanced
User may check model, S/N, firmware, health status of the disk in this interface. User also can monitor the
temperature, internal circuit, dielectric material of the disk, analysis the potential problems of the disk and
warn so as to protect its data.
7.4

Upgrade

The NVR can be upgraded by using USB flash drive. Get the upgrading software from your vendor when
there is a new software version.
Upgrade Steps:
Step 1: Copy the upgrade software which gets from vendor into the USB storage device.
Step 2: Connect the USB flash drive to the USB port.
Step 3: Enter MenuUpgrade tab. Then the upgrade software name would be displayed in the upgrade
list box.
Step 4: Select that software and then click upgrade button. It will upgrade automatically.
Note: Please wait for a while when the system reboots. Never cut off power during upgrading. The original configuration will be
reserved after upgrade.
7.5

Logoff

Enter into Menu  Logoff tab. A log off dialogue box will pop up. The device will log off by clicking "OK"
button. If you want to log in again, click Menu icon to enter into user name and password to re-login.
Fig 6-2 Information Configuration-QRCODE