Access Panel - HP ProLiant ML350p Gen8 Maintenance And Service Manual

After performing the installation or maintenance procedure, slide the server back into the rack, and then
3.
press the server firmly into the rack to secure it in place.
WARNING:
latches and sliding the server into the rack. The sliding rails could pinch your fingers.

Access panel

WARNING:
internal system components to cool before touching them.
CAUTION:
Operating the server in this manner results in improper airflow and improper cooling that can
lead to thermal damage.
To remove the component:
Do one of the following:
1.
For tower models, open and remove the bezel
o
For rack models, if installed, remove the security bezel (on page 27).
o
Power down the server (on page 26).
2.
Remove all power:
3.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
4.
For tower models, place the server on a flat, level surface with the access panel facing up.
o
For rack models, extend the server from the rack (on page 28).
o
Open the locking latch, slide the access panel to the rear of the chassis, and then remove the access
5.
panel.
If the locking latch is locked, use a T-15 Torx screwdriver to unlock it.
To reduce the risk of personal injury, be careful when pressing the server rail-release
To reduce the risk of personal injury from hot surfaces, allow the drives and the
Do not operate the server for long periods with the access panel open or removed.
("Remove the tower bezel" on page 27).
Removal and replacement procedures 29