HP ProLiant ML350p Gen8 Maintenance And Service Manual page 59

To remove the component:
Do one of the following:
1.
For tower models, open and remove the bezel
o
For rack models, if installed, remove the security bezel (on page 27).
o
Power down the server (on page 26).
2.
Remove all power:
3.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
4.
For tower models, place the server on a flat, level surface with the access panel facing up.
o
For rack models, extend the server from the rack (on page 28).
o
Remove the access panel
5.
Remove the air baffle
6.
Open the heatsink retaining levers.
7.
("Access panel" on page 29).
("Air baffle" on page 30).
("Remove the tower bezel" on page 27).
Removal and replacement procedures 59