Extend The Server From The Rack - HP ProLiant ML350p Gen8 Maintenance And Service Manual

Remove all power:
3.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Extend the server from the rack (on page 28).
4.
Remove the access panel
5.
Loosen the rack bezel thumbscrews located inside the chassis.
6.
Remove the rack bezel.
7.

Extend the server from the rack

IMPORTANT:
internal components.
Pull down the quick release levers on each side of the server.
1.
Extend the server from the rack.
2.
WARNING:
adequately stabilized before extending a component from the rack.
WARNING:
latches and sliding the server into the rack. The sliding rails could pinch your fingers.
("Access panel" on page 29).
If the server is installed in a telco rack, remove the server from the rack to access
To reduce the risk of personal injury or equipment damage, be sure that the rack is
To reduce the risk of personal injury, be careful when pressing the server rail-release
Removal and replacement procedures 28