Fan Cage - HP ProLiant ML350p Gen8 Maintenance And Service Manual

Remove the fan.
6.
To replace the component, reverse the removal procedure.

Fan cage

IMPORTANT:
be removed. To prevent an orderly or immediate server shutdown, HP highly recommends
powering down the server during these procedures. To determine if powering down is required,
see the specific procedure.
To remove the component:
Do one of the following:
1.
For tower models, open and remove the bezel
o
For rack models, if installed, remove the security bezel (on page 27).
o
Power down the server (on page 26).
2.
Remove all power:
3.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
4.
For tower models, place the server on a flat, level surface with the access panel facing up.
o
For rack models, extend the server from the rack (on page 28).
o
Remove the access panel
5.
Remove the air baffle
6.
When installing or replacing server components, one or more fans might need to
("Access panel" on page 29).
("Air baffle" on page 30).
("Remove the tower bezel" on page 27).
Removal and replacement procedures 33