Access Panel Removal - HP Integrity rx2800 i2 Installation Manual

6. Remove the server access panel.
Figure 3-4 Access panel removal
The server is ready for servicing.
Once servicing is complete, do the following to put the pedestal kit back on the server.
1. Close the access panel.
2. Install the right side pedestal piece.
3. Tighten the thumbscrews on the rear of the server.
4. Stand the server up onto the bottom piece of the pedestal kit.
5. Install the pedestal kit feet into the slots on the bottom of the pedestal kit.
6. Connect the cables and restart the server.
19