Power down the server (on page 26).
2.
Remove all power:
3.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
4.
For tower models, place the server on a flat, level surface with the access panel facing up.
o
For rack models, extend the server from the rack (on page 28).
o
Access the product rear panel.
5.
Remove all power supply modules from the power supply cage
6.
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the power supply or
power supply blank to cool before touching it.
Remove the screws, and slide the power supply cage out of the server:
7.
Two-bay power supply configuration
o
("Power supply
module" on page 41).
Removal and replacement procedures 42