Extend The Server From The Rack - HP ProLiant DL20 Gen10 User Manual

Extend the server from the rack

Extend the server from the rack
WARNING: WARNING:
To reduce the risk of personal injury or equipment damage, be sure that the rack is adequately
stabilized before extending a component from the rack.
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a T-25 Torx screwdriver available.
Procedure Procedure
1. If installed, remove the front bezel .
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Do one of the following:
For a server that has thumbscrew chassis ears , do the following:
a. Loosen the captive thumbscrews that secure the server to the rack.
b. Slide the server out of the rack.
For a server that has quick-release latch chassis ears , do the following:
a. Open the latches on both sides of the server.
b. If necessary, loosen the shipping screws.
c. Slide the server out of the rack.
Extend the server from the rack 35