Martin Tripix 300 User Manual page 46

Installing a diffuser filter in the Tripix Wash
1. Disconnect the Tripix Wash from power. If the fixture has been in
use, allow it to cool for at least 5 minutes.
2. Remove the screws from the fixture housing to release the front
cover (See Figure 37).
3. Remove the old diffuser filter (if fitted) and install the new diffuser
(arrowed in Figure 37) by putting it into the front cover with its matt
side facing in towards the LEDs.
4. Set the fixture upright (see figure 38) and check that the front cover
seal is correctly seated in its slot all the way round the edge of the
fixture housing. If the seal is not correctly seated, use one hand to
press the seal into its slot in one place, then use the other hand to
press the seal into the slot, moving round the slot until the seal is
correctly seated all the way round the housing.
46
Figure 37: Remove the screws
TM
Tripix Series user manual