Martin Tripix 300 User Manual page 24

3. Connect the "Out" connector on the Tripix Power Inserter cable to
the first Tripix fixture's power/data input cable tail.
4. Connect the first fixture's power/data output cable tail to the next
fixture's power/data input cable tail.
5. Continue connecting Tripix fixtures' power/data output cable tails to
input tails to form a chain. Do not exceed the maximum permitted
number of fixtures in one chain for the Tripix Power device you are
using (see warnings under Tripix system overview on page 19).
6. See Figure 14. When all groups of fixtures are connected correctly,
insert a Martin 13-pin DIN DMX Termination Plug in the output
connector of the last fixture of each separate chain of fixtures. One
plug is supplied with each Tripix Power or Tripix Power IP66.
Additional plugs can be ordered from Martin (P/N 91611336).
7. If DMX control is required, or if you want to configure fixtures using
a PC running the Martin MUM application and a USB/DMX
interface such as the Martin DABS1™ Hardware Interface (P/N
91611144), connect the output from the DMX controller or
USB/DMX interface to the "In" connector of the Power Inserter
cable, using a Tripix DMX Input Adapter cable.
8. Apply power and check that the system works as intended.
Extensions and advanced system connections
If the integral cable tails supplied with Tripix devices are too short, the
Tripix system can be extended using Tripix Extension Cables or Tripix
Cable Adapters.
Tripix Extension Cables
Tripix Extension Cables have the same IP66 connectors as Tripix
fixtures and can be inserted anywhere in the link to extend it.
24
Figure 14: DMX termination plug
TM
Tripix Series user manual