Martin Tripix 300 User Manual page 11

To mount a Tripix 300 or 1200 fixture on a surface using 35 mm DIN
rail:
1. Fasten the DIN rail securely to the mounting surface.
2. See Figure 2. The fixture mounting bracket has a hooked profile on
one side (see A). Hook this profile over the top of the DIN rail and
swing the bracket down. Use a 2.5 mm Allen key to tighten the
mounting clamp screw (see B).
A
3. If there is any danger of the fixture causing injury or damage if it
falls, secure it with a secondary attachment such as an approved
safety cable attached to a secure anchoring point in the mounting
surface.
Mounting the Tripix 300/1200 vertically
The mounting clamp screws will not hold a product securely on the DIN
rail if it is installed vertically. You must therefore insert screws in the
mounting surface through the DIN rail mounting holes (see arrow in
Figure 3) so that the fixture mounting clamps rest against these screws
and secure the fixture.
Tripix
Figure 2: Mounting on DIN rail
TM
Series User Manual
B
11