Table of Contents
Advertisement
•
Use only Martin approved accessories to mask or modify the
light beam.
•
Do not attempt to bypass fuses. Replace defective fuses with
ones of the specified type and rating only.
•
Install the Tripix Power indoors in a well-ventilated area only.
The Tripix Power IP66 can be installed outdoors. Provide a
minimum clearance of 5 cm (2 in.) and ensure unrestricted
airflow around all Tripix devices.
PROTECTION FROM INJURY
•
Do not look at LEDs with a magnifying glass or any other
optical instrument that may concentrate the light output.
•
Ensure that all external covers, components and installation
fittings are securely fastened.
•
Block access below the work area and work from a stable
platform whenever installing, servicing or moving the devices.
•
Ensure that all supporting structures, surfaces, fasteners and
lifting equipment can bear the weight of all the devices they
are intended to support plus an adequate safety margin, and
that they conform to local building and safety regulations.
•
Use a sufficient number of fasteners with sufficient corrosion
resistance, dimensions and strength to mount the DIN rail
safely. Any nuts used must be self-locking.
•
If there is a danger of injury or damage if a Tripix device falls,
secure it with an approved secondary attachment such as a
safety cable looped around the device or passed through a
mounting hole and anchored securely in the mounting surface.
Disposing of this product
Martin™ products are supplied in compliance with Directive
2002/96/EC of the European Parliament and of the Council of
the European Union on WEEE (Waste Electrical and
Electronic Equipment), as amended by Directive
2003/108/EC, where applicable.
Help preserve the environment! Ensure that this product is
recycled at the end of its life. Your supplier can give details of
local arrangements for the disposal of Martin products.
Advertisement
Table of Contents
