Martin Tripix 300 User Manual page 45

4. Remove the old diffuser filter (if fitted) and install the new diffuser
by putting it into the front cover with its matt side facing out
towards the front glass. To avoid light leakage, bend the edges of
the diffuser as shown in Figure 35.
Figure 35: Installing the Tripix 300/1200 diffuser
5. Check that the front cover seal is correctly seated in its slot all the
way round the edge of the front cover. If the seal is not correctly
seated, use one hand to press the seal into its slot in one place,
then use the other hand to press the seal into the slot, moving
round the slot until the seal is correctly seated all the way round
the front cover.
6. Put the front cover back and cross-tighten all screws gradually in
steps to a torque of 1.0 Nm ± 0.1 Nm.
Tripix
Figure 36: Front cover screws
TM
Series User Manual 45