Martin Tripix 300 User Manual page 4

PROTECTION FROM ELECTRIC SHOCK
•
The Tripix Power IP66 does not have a power on/off switch.
Make sure that a means of isolating this device from power
(an on/off switch or a power plug that can be removed from a
power outlet) is easily accessible.
•
Shut down power to the entire installation at the main power
distribution board and lock out power (by removing the fuse at
the distribution board for example) before carrying out any
installation or maintenance work.
•
Isolate devices from AC power before removing or installing
any cover or part and when not in use.
•
Connect the Tripix Power and Tripix Power IP66 electrically to
ground (earth).
•
Use only a source of AC power that complies with local
building and electrical codes and has both overload and
ground-fault (earth-fault) protection.
•
Before using the devices, check that all power distribution
equipment and cables are in perfect condition and are rated
for the current requirements of all connected devices.
•
Isolate all devices from power immediately if any cable, seal,
cover or other component is damaged, cracked or deformed.
Do not reapply power until repairs have been completed.
•
The Tripix Power is for indoor use only. The Tripix Power IP66
can be installed outdoors.
•
Refer any service operation not described in this manual to an
authorized Martin Service partner.
PROTECTION FROM FIRE AND BURNS
•
Do not operate fixtures or the Tripix Power IP66 if the ambient
temperature (Ta) exceeds 45° C (113° F). Do not operate the
Tripix Power if the Ta exceeds 40° C (104° F).
•
The exterior surfaces of the Tripix fixtures, Tripix Power and
Tripix Power IP66 can become hot, up to 65° C (149° F),
during normal operation. Ensure that accidental physical
contact with the devices is impossible.
•
Allow all Tripix devices to cool for 5 minutes before servicing.
•
Install Tripix devices at least 20 cm (8 in.) away from
combustible materials (for example textiles, wood, paper).
•
Keep flammable materials well away from Tripix devices.
•
Do not modify any Tripix device in any way not described in
this manual. Only install genuine Martin parts.