Installation - NEC Express5800/R120d-2E User Manual

Chapter 2 Preparations

1.10.5 Installation

Install a DIMM by using the following procedure.
1. Refer to steps 1 to 6 in Chapter 2 (1.3 Overview of Installation and Removal) for preparations.
2. Lift the processor duct off the server.
3. Open levers on left and right sides of
DIMM slot, and push the DIMM straight
into the socket.
When a DIMM is inserted into the socket,
the lever automatically closes.
4. Continue to install or remove internal optional devices, mount and connect the server, and turn it on.
5. Confirm that no error messages are displayed in POST screen.
If any error messages are displayed, refer to Chapter 3 (1. POST Error Message) in "Maintenance
Guide".
6. Run the SETUP utility, and select Memory Configuration and then Memory Information from the
Advanced menu. Make sure the capacity of added DIMM is displayed properly.
Refer to Chapter 2 (1. System BIOS) in "Maintenance Guide".
7. Select Memory Configuration from the Advanced menu, and then specify Yes for Memory Retest.
After that, select Save Changes and Exit to reboot.
8. Set the paging file size to the recommended value (Total memory size x 1.5) or more.
If using a Windows OS, refer to Chapter 1 (7.1 Specifying Memory Dump Settings (Debug Information))
in "Installation Guide (Windows)".
For other OS, consult the manual provided with the operation system or contact the store where you
purchased it or your maintenance service company.
68
• Make sure the orientation of the DIMM. The terminal side of a DIMM has a
Important
notch, preventing being wrongly inserted.
• Do not apply too much pressure when you push a DIMM into the socket.
Doing so can damage the socket or terminal part.
Express5800/R120d-2E User's Guide
1. Installing Internal Optional Devices
Key slot
Key