Connecting To A Uninterruptible Power Supply (Ups) - NEC Express5800/R120d-2E User Manual

Chapter 2 Preparations
2.2.1

Connecting to a uninterruptible power supply (UPS)

To connect the power cord of the server to the uninterruptible power supply (UPS), use the connector
output on the rear of the UPS. For details, refer to the manual supplied with the UPS.
Example
Option slot
Input connector
(NEMA5-15P)
When the power cord is connected to a UPS, the BIOS settings may need to be changed in order to link the
server with the power supply from the UPS.
To change the settings, select Server and then AC-LINK in the BIOS setup utility, and change the
displayed parameters. Select Power On to perform automatic operations by using the UPS. For details,
refer to Chapter 2 (1.2.4 Server) in "Maintenance Guide".
Computer interface port (UPS)
Overload protection
reset button
Computer interface port (COM)
Voltage sensitivity setting button
Express5800/R120d-2E User's Guide
2. Installation and Connection
Connector outputs
TVSS device connector
139