NEC Express5800/R120d-2E User Manual page 86

Chapter 2 Preparations
10. Start the BIOS Configuration utility on the mounted board to set up the board.
Availability or startup and operation procedure of the utility depends on board. For details, refer to the
manual that comes with the board. If a PCI card including RAID Controller, SCSI controller, and LAN
card which connects to any bootable device is added, the boot priority might be changed to the default
setting. In that case, configure the boot priority in the Boot menu of the BIOS Setup utility. For details
about the Boot menu, refer to Chapter 2 (1.2.5 Boot) in "Maintenance Guide".
(2) When using the optional controller (N8103-160)
For details, refer to the manual that comes with optional RAID Controller (N8103-160).
1.13.4 Removal
To remove a riser card, reverse the installation procedure. Hold the card firmly and remove it. When
removing it, have another person hold the server so that the server does not move.
If needed, run SETUP utility, and then specify the boot order from the Boot menu. For details about the
Boot menu, refer to Chapter 2 (1. System BIOS) in "Maintenance Guide".
If using the server while the card is removed, attach the slot cover that comes with the riser card.
86
• You must avoid static electricity to work with the procedure below. For
Important
details, refer to Chapter 2 (1.2 Anti-static Measures).
• Do not change the mode to hibernate when building a RAID System.
• When installing an optional RAID Controller, start the BIOS Setup utility, select
Note
PCI Configuration from the Advanced menu, and then make sure that the
parameter of PCI Slot xx ROM (xx is PCI slot number) is set to Enabled.
• When connecting a RAID Controller, set the boot priority to 8th or higher in the
Boot menu of the BIOS Setup utility. If the setting is 9th or lower, the
configuration menu for RAID Controllers cannot be launched.
Express5800/R120d-2E User's Guide
1. Installing Internal Optional Devices