NEC Express5800/R120d-2E User Manual page 82

Chapter 2 Preparations
5.
Remove the two screws from RAID
Controller, and remove PCI bracket.
6.
Install the controller bracket to RAID
Controller with two screws you have
removed in Step 5.
7. Install RAID Controller to the riser card.
When installing the card, position the
terminal part of the PCI card to the riser
card slot and insert it. Secure the card
with a screw you removed in Step 4.
82
Important
Do not touch the terminal part of riser cards or PCI cards and the signal pins
of electric parts installed on the card. Installing cards with dirt or oil can
cause malfunction.
• Make sure that the head of a PCI card bracket is seated into the fixed slot.
Note
• Depending on type of PCI cards, the terminal part of the PCI card may be too
large to fit in the connector.
• If you have trouble in installing the card, remove the card once and try again. If
you apply excessive pressure on the card, a PCI card or riser card might break.
Tips
Connect a cable between connector on HDD backplane and RAID card before
installing the riser card to the server.
Express5800/R120d-2E User's Guide
1. Installing Internal Optional Devices
Screw