NEC Express5800/R120d-2E User Manual page 133

Chapter 2 Preparations
(3) Removal procedure
Remove the server from the rack in the following procedure. At least two persons are required to remove
the server from rack.
1. Make sure that the server is turned off and then disconnect the power cord or all interface cables from
the server.
2. Unlock the security lock to remove the
front bezel
3. Slowly pull the server out while pressing
the unlock buttons located on either side
of the front of the server.
4. Because there are stoppers, the server
will come to a stop halfway. Press and
hold the release levers on the rails and
pull the server out of the rack.
5. Hold the server firmly and remove it from the rack.
Important
Be careful not to get your fingers caught in the rails and levers.
• While more than one person is supporting the bottom part of the server,
Important
slowly pull out the server.
• Do not apply pressure on the server from top when it is being pulled out.
Doing so cause the server to drop, which is dangerous.
• Be careful not to get your finger caught in rails.
Express5800/R120d-2E User's Guide
2. Installation and Connection
Press the button
to unlock
Rail Stopper
133