Setting Log Book Print; Setting Log Output Length; Setting Transfer Speed; Setting Printer Model Selection - JRC JFE-380 Instruction Manual

When PRINTER PORT OUT is "PC"
COPY Data cannot be output.
HISTORY Memorized all data and maintenance system information are output.
LOG This data output is available only the history display

Setting Log Book Print

This item selects automatic LOG book print mode.
When select this interval setting menu to 0.5min*, 1min, 2min, 5min, 10min,
depth data will automatically print with every selected interval. * 0.5min
interval is available only MEMORY LENGTH setting as 12 hours. If 24 hours
is set, 0.5min runs 1min interval. "OFF" stops automatic LOG book print
mode.
NOTE: When GPS position data is connected to JFE-380, LAT/LON
position data would print.
Select "LOG BOOK PRINT" with
the [ENT] key to enter the automatic LOG book print interval setting.
Detail item OFF/0.5min/1min/2min/5min/10min
Select the output length by

Setting Log Output Length

This item selects LOG output length on the HISTORY display mode with LOG print mode.
Select "LOG LENGTH" with
setting.
Detail item 10min/20min/30min/1hr/2hr
Select the output length by

Setting Transfer Speed

This item selects data output baud rate. Only 4800bps is suitable to paper print. If you set other baud
rate, unusual characters might print out. This item is used with 4.7 communication setting/printer port out :
PC.
Select "SPEED" with
Detail item 4800bps/9600bps/19200bps/38400bps
Select the baud rate by

Setting Printer Model Selection

This item selects printer model from NKG-91/ DPU-414.
When the print or the data output is operated, it becomes an error.
mode. Data and maintenance system information in
the same time as the case of above-mentioned
"PRINTER" LOG are output.
or
and press the [ENT] key.
or key. Then press
and press the [ENT] key.
or key. Then press
and press the [ENT] key.
key. Then press or
or the [ENT] key to enter the detail
or the [ENT] key to enter the detail setting.
4. Operation 33