Chapter 1
Workflow
This chapter describes the procedure for connecting ETERNUS DX storage systems to a server running Solaris
OS.
Procedures may vary according to the Fibre Channel card driver type and connection method.
When a Fibre Channel switch is used to make the connection, refer to the "FUJITSU Storage ETERNUS DX
Configuration Guide -Server Connection- (Fibre Channel) Fibre Channel Switch Settings" and use the proce-
dure described.
1.1
For Fujitsu Drivers
The following documents may be relevant when using a Fujitsu driver.
Exactly which documents are required depends on the connection environment, see the "Workflow" section
that follows for details.
Required Documents
"Server Support Matrix"
•
•
"Server Support Matrix for FC-SWITCH"
"FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- Disk Storage System Settings" that
•
corresponds to the ETERNUS DX to be connected
"FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (Fibre Channel) Fibre Channel
•
Switch Settings"
"FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (Fibre Channel) for Oracle Solaris
•
Driver Settings for Fujitsu Fibre Channel Cards"
"FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (Fibre Channel) for Oracle Solaris
•
Multipath Driver Settings"
"ETERNUS Web GUI User's Guide"
•
"ETERNUSmgr Install Guide"
•
•
"ETERNUSmgr User Guide"
Manuals supplied with the Fibre Channel card, multipath driver, and VxVM
•
FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (Fibre Channel) for Oracle Solaris
6
Copyright 2015 FUJITSU LIMITED
P3AM-3702-16ENZ0