Chapter 1 Workflow - Fujitsu ETERNUS DX S4 Series Configuration Manual

Chapter 1
Workflow
This chapter describes how to connect the ETERNUS DX/AF to a server running AIX. The workflow is shown
below.
Required Documents
"Server Support Matrix"
•
• "Server Support Matrix for FC-SWITCH"
"Configuration Guide -Server Connection- Storage System Settings" that corresponds to the ETERNUS DX/AF
•
to be connected
"Configuration Guide -Server Connection- (Fibre Channel) Fibre Channel Switch Settings"
•
"ETERNUS Web GUI User's Guide"
•
"ETERNUSmgr Install Guide"
•
"ETERNUSmgr User Guide"
•
• Manuals supplied with the server, Fibre Channel card, Fibre Channel card driver, and multipath driver
Workflow
Installing ETERNUSmgr and Setting Up the ETERNUS DX/AF
If ETERNUSmgr is to be used, install it and set up the ETERNUS DX/AF. Also, check the WWN of the
Fibre Channel card for the server that is required to set the ETERNUS DX/AF.
"Chapter 4 Checking the Server Information" (page 16)
•
"Chapter 5 Installing and Setting Up ETERNUSmgr" (page 17)
•
"Chapter 6 Setting Up the ETERNUS DX/AF" (page 18)
•
Checking the setup and maintenance operations
•
- "ETERNUS Web GUI User's Guide"
Installing ETERNUSmgr
•
"ETERNUSmgr Install Guide"
-
• Checking the ETERNUSmgr operational procedures
"ETERNUSmgr User Guide"
-
Setting up the ETERNUS DX/AF
•
"Configuration Guide -Server Connection- Storage System Settings" that corresponds to the ETER-
-
NUS DX/AF to be connected
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (Fibre Channel) for AIX
7
Copyright 2018 FUJITSU LIMITED
P3AM-3782-23ENZ0