Fibre Channel Switch Notes - Fujitsu ETERNUS DX Configuration Manual

Chapter 3 Notes
3.4

Fibre Channel Switch Notes

3.4 Fibre Channel Switch Notes
When a Fibre Channel switch (ETERNUS SN200 series, Brocade series) is to be used between the server and
ETERNUS DX, follow the preparation-in-advance and Fibre Channel switch setup procedures given in the "FU-
JITSU Storage ETERNUS DX Configuration Guide -Server Connection- (Fibre Channel) Fibre Channel Switch Set-
tings".
Which Fibre Channel switches can be connected to the ETERNUS DX varies depending on the connection
•
environment (server OS and ETERNUS DX model). Refer to "Server Support Matrix for FC-SWITCH" to check
the available Fibre Channel switches in advance.
• When connecting any of the following Fibre Channel cards to a Fibre Channel switch, Fibre Channel switch
ports must be set:
SP1X7FAB2F
-
SP1X7FAA2F
-
SP1X5FAA2F
-
SE0X7F22F
-
- SE0X7F21F
XSPFC212A
-
XSPFC202A
-
XSPFC211A
-
XSPFC201A
-
- Oracle Fibre Channel cards (with a "QF" or "QL" designation model name)
QLogic Fibre Channel cards (using Oracle brand drivers)
-
Set the link speeds of the Fibre Channel switch ports that connect to the Fibre Channel cards installed in
the server according to the following table:
Combination of the devices
Maximum link speed of Fibre Channel
card
16Gbit/s
8Gbit/s
4Gbit/s
2Gbit/s
FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (Fibre Channel) for Oracle Solaris
Maximum link speed of the Fibre
Channel switch
16Gbit/s
8Gbit/s
4Gbit/s
2Gbit/s
16Gbit/s
8Gbit/s
4Gbit/s
2Gbit/s
16Gbit/s
8Gbit/s
4Gbit/s
2Gbit/s
16Gbit/s
8Gbit/s
4Gbit/s
2Gbit/s
27
Copyright 2015 FUJITSU LIMITED
Set the Fibre Channel switch port link
speed to ...
16Gbit/s fixed
8Gbit/s fixed
4Gbit/s fixed
-
8Gbit/s fixed
8Gbit/s fixed
4Gbit/s fixed
2Gbit/s fixed
4Gbit/s fixed
4Gbit/s fixed
4Gbit/s fixed
2Gbit/s fixed
-
2Gbit/s fixed
2Gbit/s fixed
2Gbit/s fixed
P3AM-3702-16ENZ0