Fujitsu ETERNUS DX Configuration Manual page 18

Chapter 1 Workflow
1.4 For QLogic Drivers
Setting Up the Fibre Channel Switches
If a Fibre Channel switch is to be used, set it up now.
"Chapter 6 Setting Up the Fibre Channel Switches" (page 34)
•
Setting up the Fibre Channel switches
•
"FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (Fibre Channel) Fibre
-
Channel Switch Settings"
Checking the Fibre Channel switch connection requirements
•
"Server Support Matrix for FC-SWITCH"
-
Installing the Driver
Install the appropriate driver for the Fibre Channel card being used.
"Chapter 7 Installing Drivers and Setting Up the Server" (page 36)
•
Installing Fibre Channel cards and drivers
•
"FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (Fibre Channel) for Oracle
-
Solaris Driver Settings for Non-Fujitsu Fibre Channel Cards"
Checking the Fibre Channel card driver versions
•
"Server Support Matrix"
-
Setting Up the Server
Edit the setup file (/kernel/drv/qla2300.conf) to set the parameters required for connection.
"Chapter 7 Installing Drivers and Setting Up the Server" (page 36)
•
Setting up the server
•
"FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (Fibre Channel) for Oracle
-
Solaris Driver Settings for Non-Fujitsu Fibre Channel Cards"
Setting Up the Server to Recognize the Logical Units and Labeling LUN (sd Driver)
Edit the setup file (/kernel/drv/sd.conf) to allow the sd driver to recognize the ETERNUS DX storage sys-
tems' logical units. Then, label the LUNs using the "format" command.
Setting up the server
•
"FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (Fibre Channel) for Oracle
-
Solaris Driver Settings for Non-Fujitsu Fibre Channel Cards"
FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (Fibre Channel) for Oracle Solaris
18
Copyright 2015 FUJITSU LIMITED
P3AM-3702-16ENZ0