For Qlogic Drivers - Fujitsu ETERNUS DX Configuration Manual

Chapter 1 Workflow
1.4

For QLogic Drivers

1.4 For QLogic Drivers
The following documents may be relevant when using a QLogic driver.
Exactly which documents are required depends on the connection environment, see the "Workflow" section
that follows for details.
Required Documents
"Server Support Matrix"
•
"Server Support Matrix for FC-SWITCH"
•
"FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- Disk Storage System Settings" that
•
corresponds to the ETERNUS DX to be connected
"FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (Fibre Channel) Fibre Channel
•
Switch Settings"
"FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (Fibre Channel) for Oracle Solaris
•
Driver Settings for Non-Fujitsu Fibre Channel Cards"
"ETERNUS Web GUI User's Guide"
•
• "ETERNUSmgr Install Guide"
"ETERNUSmgr User Guide"
•
Manuals supplied with the Fibre Channel card and VxVM
•
Workflow
Installing ETERNUSmgr and Setting Up the ETERNUS DX
If ETERNUSmgr is to be used, install it and set up the ETERNUS DX.
• "Chapter 4 Installing and Setting Up ETERNUSmgr" (page 32)
"Chapter 5 Setting Up the ETERNUS DX" (page 33)
•
Checking the setup and maintenance operations
•
- "ETERNUS Web GUI User's Guide"
"ETERNUSmgr Install Guide"
-
"ETERNUSmgr User Guide"
-
Setting up the ETERNUS DX
•
"FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- Disk Storage System Set-
-
tings" that corresponds to the ETERNUS DX to be connected
FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (Fibre Channel) for Oracle Solaris
17
Copyright 2015 FUJITSU LIMITED
P3AM-3702-16ENZ0