Remote Control Operation - Procom FBD32RT Manual

REMOTE CONTROL OPERATION

MATCHING SECURITY CODES
When matching security codes, be sure slide button on the receiver is in the REMOTE position. To
program the remote receiver to LEARN a new security code, press and release the LEARN button on
the top of the remote receiver, and then press ON or OFF button on the transmitter. A change in the
beeping pattern at the receiver, indicates the transmitter's code has been programmed into the receiver.
REMOTE CONTROL OPERATION
This appliance must not be used with glass doors in the closed position.
This can lead to pilot outages and severe sooting outside the fireplace.
The transmitter operates on two AAA batteries.
KEY SETINGS
ON - Operates unit to on position, Manually operated solenoid ON.
OFF - Operates unit to off position, Manually operated solenoid OFF.
MODE -Changes unit from manual mode to thermo mode.
SET - Sets temperature in thermo mode.
LCD Liquid Crystal Display
1. DISPLAY Indicates CURRENT room temperature.
2. °F OR °C Indicates degrees Fahrenheit or Ceisius.
3. FLAME Indicates bumer/valve in operation.
4. ROOM Indicates remote is in THERMO operation.
5. TEMP Appears during manual operation.
6. SET Appears during time the of setting the desired
temperature in the thermo operation.
SETTING°F/°C SCALE
The factory setting for temperature is °F. To change this setting to°C .
First
Press the ON key and the OFF key on the transmitter at the same time
this will change from°F to °C. Follow this same procedure to change from°C
back to°F.
MANUAL FUNCTION
To operate the system in the manual "MODE" do the following.
ON OPERATION
Press the ON key and the appliance flame will come on.
During this time the LCD screen will show ON (Figure 28).
After 3 seconds the LCD screen will default to display
room temperature and the word TEMP will show (Figure 29).
(Flame icon will appear on LCD screen in manual
on mode).
Figure 28
22
Figure 24
Figure 25
Figure 26
Figure 27
Figure 29