Motorola AP-51 Series Product Reference Manual page 313

Status
IP Address
Network Mask
Ethernet Address
Link
Speed
Duplex
WLANs Mapped
3. Refer to the Received
RX Packets
RX Bytes
Displays whether this particular LAN has been enabled as viable
subnet from within the LAN Configuration screen.
The Internet Protocol (IP) addresses for the access point LAN port.
The first two sets of numbers specify the network domain, the next
set specifies the subset of hosts within a larger network. These
values help divide a network into subnetworks and simplify routing
and data transmission.
The Media Access Control (MAC) address of the access point. The
MAC address is hard coded at the factory and cannot be changed.
For more information on how access point MAC addresses are
assigned, see AP-51xx MAC Address Assignment on page
The Link parameter displays
between the access point and network, and
connection is interrupted or lost. Use this information to assess the
current connection status of LAN 1 or LAN2.
The LAN 1 or LAN 2 connection speed is displayed in Megabits per
second (Mbps), for example, 54Mbps. If the throughput speed is
not achieved, examine the number of transmit and receive errors,
or consider increasing the supported data rate. To change the data
rate of the 802.11a or 802.11b/g radio, see
or 802.11b/g Radio on page
Displays whether the current LAN connection is full or half duplex.
The WLANs Mapped table lists the WLANs mapped to this LAN
(either LAN1 or LAN2) as their LAN interface.
field to view data received over the access point LAN port.
RX packets are data packets received over the access point LAN
port. The number is a cumulative total since the LAN connection
was last enabled or the access point was last restarted. To begin a
new data collection, see
RX bytes are bytes of information received over the LAN port. The
value is a cumulative total since the LAN connection was last
enabled or the access point was last restarted. To begin a new data
collection, see Configuring System Settings on page
Up if the LAN connection is active
Down
Configuring the 802.11a
5-55.
Configuring System Settings on page
Monitoring Statistics
1-28.
if the LAN
4-2.
4-2.
7-7