Motorola AP-51 Series Product Reference Manual page 62

2-18 AP-51xx Access Point Product Reference Guide
CAUTION Both the Dual and Single Radio model AP-5131s use RSMA type
!
4. Cable the AP-5131 using either the Power Injector solution or an approved line cord and
power supply.
CAUTION Do not supply power to the AP-5131 until the cabling of the unit is
!
For Power Injector installations:
a. Connect a RJ-45 Ethernet cable between the network data supply (host) and the Power
Injector Data In connector.
b. Connect a RJ-45 Ethernet cable between the Power Injector Data & Power Out
connector and the AP-5131 LAN port.
c. Ensure the cable length from the Ethernet source (host) to the Power Injector and
AP-5131 does not exceed 100 meters (333 ft). The Power Injector has no On/Off power
switch. The Power Injector receives power as soon as AC power is applied. For more
information on using the Power Injector, see
page
For standard 48-Volt Power Adapter (Part No. 50-14000-243R) and line cord installations:
a. Connect RJ-45 Ethernet cable between the network data supply (host) and the AP-5131
LAN port.
b. Verify the power adapter is correctly rated according the country of operation.
c. Connect the power supply line cord to the power adapter.
d. Attach the power adapter cable into the power connector on the AP-5131.
e. Plug the power adapter into an outlet.
5. Verify the behavior of the AP-5131 LEDs. For more information, see
on page
6. Align the bottom of the ceiling T-bar with the back of the AP-5131.
antenna connectors. On a Dual Radio AP-5131, a single dot on the
antenna connector indicates the primary antenna for both Radio 1 (2.4
GHz) and Radio 2 (5 GHz). Two dots designate the secondary antenna
for both Radio 1 and Radio 2. On Single Radio models, a single dot on
the antenna connector indicates the primary antenna for Radio 1, and
two dots designate the secondary antenna for Radio 1
complete.
2-10.
2-23.
Power Injector and Power Tap Systems on
AP-5131 LED Indicators