Motorola AP-51 Series Product Reference Manual page 613

Radio Status and
network, these values update in real-time.
CAUTION If a radio is disabled, be careful not to accidentally configure a new
!
3. Select the Base Bridge
connections from other access points in client bridge mode. The base bridge is the acceptor
of mesh network data from those client bridges within the mesh network and never the
initiator.
CAUTION A problem could arise if a Base Bridge's Indoor channel is not
!
4. If the Base Bridge checkbox has been selected, use the
to define the client bridge load on a particular base bridge.
The maximum number of client bridge connections per access point radio is 12, with 24
representing the maximum for dual-radio models.
CAUTION An access point in Base Bridge mode logs out whenever a Client
!
Once the settings within the Radio Configuration screen are applied (for an initial
deployment), the current number of client bridge connections for this specific radio displays
within the CBs Connected
value updates in real-time.
5. Select the Client Bridge
connections with other mesh network supported access points radios on the same WLAN.
MUs connected values update. If this is an existing radio within a mesh
WLAN, expecting the radio to be operating when you have forgotten it
was disabled.
checkbox to allow the access point radio to accept client bridge
available on an Outdoor Client Bridge's list of available channels. As
long as an Outdoor Client Bridge has the Indoor Base Bridge channel
in its available list of channels, it can associate to the Base Bridge.
Bridge associates to the Base Bridge over the LAN connection. This
problem is not experienced over the access point's WAN connection. If
this situation is experienced, log-in to the access point again.
field. If this is an existing radio within a mesh network, this
checkbox to enable the access point radio to initiate client bridge
Configuring Mesh Networking
Max# Client Bridges
9-15
parameter