Desk Mounted Installations; Mounting An Ap-5131 - Motorola AP-51 Series Product Reference Manual

Hide thumbs Also See for AP-51 Series:

Table of Contents

Green (Steady)

Power Injector is receiving power from an

Green (Blinking) Output voltage source is out of range.

For more information and device specifications for the Power Injector, refer to the Power Injector

Quick Install Guide (Part No. 72-70762-01) available from the Motorola Web site.

The AP-5131 can rest on a flat surface, attach to a wall, mount under a suspended T-Bar or above a

ceiling (plenum or attic). Choose one of the following mounting options based on the physical

environment of the coverage area. Do not mount the AP-5131 in a location that has not been approved

in a site survey.

Refer to the following, depending on how you intend to mount the AP-5131:

Desk Mounted Installations

Wall Mounted Installations

Suspended Ceiling T-Bar Installations

Above the Ceiling (Plenum) Installations

2.7.1 Desk Mounted Installations

The desk mount option uses rubber feet allowing the unit to sit on most flat surfaces. The four (4)

round rubber feet can be found in the AP-5131 (main) box in a separate plastic bag.

To install the AP-5131 in a desk mount orientation:

1. Turn the AP-5131 upside down.

2. Attach the radio antennae to their correct connectors.

The antenna protection plate cannot be used in a desk mount configuration, as the plate only

allows antennas to be positioned in a downward orientation.

Hardware Installation

Indicates a device is connected to the

Power Injector's outgoing Data & Power

The Power Injector is overloaded or has a

short circuit.