Motorola AP-51 Series Product Reference Manual page 129

Add
SNMP Version
3. Configure the SNMP v3 Trap Configuration
the following:
Add
Delete
Destination IP
Port
Username
Security Level
Passwords
4. Click Apply to save any changes to the SNMP Trap Configuration screen. Navigating away
from the screen without clicking the Apply button results in all changes being lost.
Click Add to create a new SNMP v1/v2c Trap Configuration entry.
Use the SNMP Version drop-down menu to specify v1 or v2.
Some SNMP clients support only SNMP v1 traps, while others
support SNMP v2 traps and possibly both, verify the correct traps
are in use with clients that support them.
Click Add to create a new SNMP v3 Trap Configuration entry.
Select Delete to remove an entry for an SNMP v3 user.
Specify a numerical (non DNS name) destination IP address for
receiving the traps sent by the access point SNMP agent.
Specify a destination User Datagram Protocol (UDP) port for
receiving traps.
Enter a username specific to the SNMP-capable client receiving
the traps.
Use the Security Level
level of noAuth (no authorization), AuthNoPriv (authorization
without privacy), or AuthPriv (authorization with privacy).
The "NoAuth" setting specifies no login authorization or encryption
for the user. The "AuthNoPriv" setting requires login authorization,
but no encryption. The "AuthPriv" setting requires login
authorization and uses the Data Encryption Standard (DES).
Select Passwords to display the
specifying authentication and password settings for an SNMP v3
user. The maximum password length is 11 characters. Use the
Authentication Algorithm
SHA1 as the authentication algorithm. Use the Privacy Algorithm
drop-down menu to define an algorithm of
If entering the same username on the SNMP Traps and SNMP
Access screens, the password entered on the SNMP Traps page
overwrites the password entered on the SNMP Access page. To
avoid this problem, enter the same password on both pages.
field (if SNMP v3 Traps are used) to modify
drop-down menu to specify a security
Password Settings
drop-down menu to specify
DES or AES-128bit.
System Configuration 4-37
screen for
MD5 or