Intercomp CW250 User Manual page 25

18. The display shows "HH-04". Press the PRINT/ACCUMULATE button. The display
will show "00000" with the far right number flashing. Use the LOCAL/TOTAL button
to advance the number and the ZERO button to move the number flashing to the
left. Enter the value of the forth load and press the PRINT/ACCUMULATE button
when the value of the forth load is displayed.
19. The display shows "LL-04". Apply the forth load to the scale. With the forth load
applied to the scale press PRINT/ACCUMULATE button.
Repeat step 12 and 13 for each additional "HH-05" – "HH-10" and "LL-05"- "LL-10"
combination. If the scale is turned off at any time the calibration data acquired to that
point will be retained. After the PRINT/ACCUMULATE button is pressed after "LL-10",
the display will return to normal weighing.
Following calibration, replace the strap to shorting pins 2 and 3 (RUN); replace the
assembly and reattach the assembly with the screws. This will ensure that the
calibration information of the scale is protected from being changed.
Note: Care must be taken to ensure the wire harness is seated properly to
prevent it from being pinched between the display assembly and the scale
casing.
Finished
Page 25 of 29
CW250, Users
Rev J, October, 2010