Intercomp CW250 User Manual page 18

"000" will disable the function, meaning the scale will never shut itself off. Use the
LOCAL/TOTAL button the advance the number and the ZERO button to move the
number flashing to the left. When the display shows the desired number, press the
PRINT/ACCUMULATE button.
8. The display will show "Prt t". Press the PRINT/ACCUMULATE button. The
flashing digit shows the current setting. The number enables the scales different
print modes. (0 for on-demand, 1 for continuous, 2 for accumulating total axle
format, and 3 for accumulating total standard format) Use the LOCAL/TOTAL button
to increment and the ZERO button to decrement the number. When the display
shows the desired number, press the PRINT/ACCUMULATE button.
9. The display will show "PbAUd". Press the PRINT/ACCUMULATE button. The
flashing display shows the current setting of the printer baud rate. The baud rates
available are: 1200, 2400, 4800, 9600, 19200, 38400, 57600, and 115200. Use the
LOCAL/TOTAL button or the ZERO button to toggle through the available rates.
When the display shows the desired number, press the PRINT/ACCUMULATE
button.
10. The display will show "UnitS". Press the PRINT/ACCUMULATE button. The lb or
the kg icon will flash in the upper left of the display. This will set the scale to
measure pounds (lb) or kilograms (kg). Use the LOCAL/TOTAL button or the ZERO
button to toggle between the settings. When the desired icon is flashing, press the
PRINT/ACCUMULATE button.
11. The display will show "Proto". Press the PRINT/ACCUMULATE button. The
flashing display shows the current setting. There are 4 protocol settings for the
scale, Standard ("StAnd"), Low Power ("Lo Pr"), Current Loop ("C.L00P"), or "None"
Standard is the legacy setting for use in wireless and wired scale networks. Low
Power will significantly improve the wireless battery life for all non-'host' scales.
(maximum number of scales in this mode is 32) Current Loop is not used in the
CW250. When scales are not part of a totalizing network, battery life will be
improved if "nonE" is chosen. Use the LOCAL/TOTAL button or the ZERO button to
cycle through the settings. When the desired protocol is flashing, press the PRINT/
ACCUMULATE button.
12. The display will show "i.bAud". Press the PRINT/ACCUMULATE button. The
display will show the current setting flashing. This is the setting of the interface baud
rate. There are two settings available, 9600 and 115200. Use the LOCAL/TOTAL
button or the ZERO button to toggle between the settings. When the desired baud
rate is flashing, press the PRINT/ ACCUMULATE button.
13. The display will show "rAdio". Press the PRINT/ACCUMULATE button. The display
will show the current setting flashing. This is the radio enable status and is either on
or off. Use the LOCAL/TOTAL button or the ZERO button to toggle between the
settings. When the desired status is flashing, press the PRINT/ ACCUMULATE
button. If you select "no" the scale will skip the rest of the settings and return to
normal weighing.
Page 18 of 29
CW250, Users
Rev J, October, 2010
.